The method of cleaning the laser screed’s radiator and cheking if it damage
Something dirty may fly out and into your eyes, please wear goggles and gloves.
Wash the radiator with compressed air, steam or water.
Pressure: 0.98Mpa (10kgf/cm) 2
Vapor pressure: 0.39Mpa (4kgf/cm)
If you use air or steam, be sure to clean the nozzle at a right angle to the radiator.
1.Replace hydraulic oil
When the operation is completed, the oil is at high temperature, do not change oil immediately after stopping operation, you should do that when the oil temperature become cold.
1> Unscrew the oil drain plug at the bottom of the tank to drain oil, then remove the strainer and wash it in the washing oil.
2> After cleaning the inner wall of oil tank, tighten the oil plug.
3> After cleaning the strainer, blow from the bottom of it to make it thoroughly dry, and then put it on.
4> Put on the cover after replace the filter.
5> Fill in specified amount of hydraulic oil through the inlet vent (with oil dipstick), then check the oil level with the oil dipstick.
6> Starting engine, then operate the cylinder (lift, steering, etc.) to the end of the trip to 5 ~ 6 times exhaust.
2.Replace fuse
Fuse could protect the electrical system to prevent excessive current, so you must use specified fuse. When you check whether the parts in the loop are working properly, may be the corresponding fuse has been broken, you should replace with a Equivalent capacity fuse. If some parts of the component is not working properly, maybe the spherical contact burned out,you should replace with a Equivalent capacity spherical contact.
The method of cleaning the laser screed’s radiator and cheking if it damage